How to Placing Parts : Hard Drive

Step 1 - Remove the battery
Slide and hold the battery release latch to the release position.
Lift the front edge of the battery and remove it from the battery bay.

Step 2 - Remove the hard disk drive
Loosen the two captive P1 Phillips-head screws that secure the hard disk drive cover to the bottom of the notebook.
Use your finger or a flat-bladed tool to lift the outside edge of the hard disk drive cover and remove it.
Grasp the Mylar tab and pull the hard disk drive toward the outside edge of the base enclosure to disconnect the hard disk drive from the system board connector.
Place the hard disk drive in a static dissipative bag.

Step 3 - Replace the hard disk drive
Remove the hard disk drive from the static dissipative bag.
Place the hard disk drive into the hard disk drive bay.
Push the hard disk drive toward the inside of the base enclosure until the connector is seated.
Toe the inside edge of the hard disk drive cover into the base enclosure and lower it into position.
Tighten the two captive P1 Phillips-head screws that secure the hard disk drive cover to the bottom of the notebook.

Step 4 - Replace the battery
Toe the rear edge of the battery into the base enclosure.
Lower the front edge of the battery and press the battery into the battery bay until the release latch clicks.